The other commands ip -4 addr show or ip -6 addr show did no work for me. I did ifconfig but not sure what to look after, I did not see any IP-adressses, but I did find something tht startet with FE80 Thanks for replying! Lot of info, not sure how to use this. In all cases have a look with ifconfig -a or ip -4 addr show or ip -6 addr show commands. If you don't have a routeable /64 IPv6 prefix then every machine will have a link-local FE80::xxxx:xxxx:xxxx:xxxx IPv6 address. I'm not sure how slaac generates the bottom 64 bits of the address. I've updated my /etc/nf to always use hardware EUI-64 because that's easier to find since I know all of the serial numbers for wired Raspberries and all the WiFi MAC addresses for my others. Enhancement: Supports more output message payload types. IPv6 addresses are either built from your prefix with an EUI-64 address generated from the hardware MAC-48 address or with a slaac address assigned by dhcpcd. Bug fix: Disable smux keep alive to use idle session timeout feature. If I understood correctly this means my Pi is not getting a connection?ĭougieLawson wrote:IPv4 addresses are either statically coded in /etc/nf or assigned by your home router's DHCP server. Sudo launchctl list|grep ssh I get this back: Permission denied (publickey,keyboard-interactive). Then it asked me for Password, I wrote raspberry The authenticity of host '192.168.0.11 (192.168.0.11)' can't be established.It asked me to continue (yes/no) In Advanced settings for the ethernet connection.Ĭonfigure IPv6 was set to Link-local only so switched to Automatically. It usually means youre looking at the wrong IP address (if we assume that ssh is alive and ready on port 22 on your RPi). To make your OpenSSH server keep all connections alive with clients, add the following to /etc/ssh/sshdconfig: ClientAliveInterval 300 ClientAliveCountMax 2. ssh / config The above command will create the configuration file and open the file in the nano editor to let you edit it even if it does not exist. 'connection refused' means youve got an IP address thats valid on your home LAN, but the device at that address is not listening on the target port. Alternatively, you can achieve the same result by specifying the ClientAliveInterval parameter alone. This is an equivalent of 1 hour, which implies that your ssh session will remain alive for idle time of 1 hour without dropping. Both my ethernet cable and WiFi is also green (getting connection) Keep a Terminal Session Alive by Setting Up the Configuration File To edit the configuration file of SSH, type the command given below: sudo nano HOME/. Increase SSH Timeout The Timeout value will be 1200 secoseconds. The Raspbian Operating System on your RPi is set up by default as a DHCP Client and will be offered an IP Address from your Mac's Operating System. Tmux keeps my session alive while Im away from the machine, mosh means I barely. Setup Internet Connection Sharing in OSX or MacOS (depending on which OS is installed on your Mac), this will setup a basic DHCP Server: I only wish that iTerm2s tmux compatibility would work with Mosh (.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |